Dolmar TM-98.14 H2D Manual De Instrucciones página 97

UNPACKING AND ASSEMBLY
on the inner tongue with the help of a small screwdriver.
First connect the red wire (8) to the positive
pole (+) and then the black wire (9) to the
negative pole (–), using the screws supplied
as shown.
Apply silicone grease to the terminals and
check that the protective cap for the red wire
(8) is in place.
Replace the battery in its housing making
sure that the two poles are facing the centre
of the machine, fully tighten the clamp (3)
and refit the guard (2).
IMPORTANT
the battery's manual.
IMPORTANT
cutting in, never start the engine until the battery is fully charged!
WARNING!
!
tery incorrectly fixed in its housing.
Always fully charge the battery according to the instructions in
To prevent the safety device in the electronic circuit board from
Do not use the machine without the guard (2) or with the bat-
9
1
3
11
EN
8