Makita LS002G Manual De Instrucciones página 26

Table (B)
– Molding
position in
the figure
For inside (a)
corner
(b)
For outside (c)
corner
(d)
Example:
In the case of cutting 52/38° type crown molding for
position (a) in the above figure:
• Tilt and secure bevel angle setting to 33.9° LEFT.
• Adjust and secure miter angle setting to 31.6°
RIGHT.
• Lay crown molding with its broad back (hidden)
surface down on the turn base with its CEILING
CONTACT EDGE against the guide fence on the
saw.
• The finished piece to be used will always be on
the LEFT side of the circular saw blade after the
cut has been made.
In the case of right bevel cut
(a) (b)
1. Inside corner 2. Outside corner
Table (A)
– Molding Bevel angle
position
52/38°
in the
type
figure
For (a) Right
inside 33.9°
corner
(b)
For (c)
outside
(d)
corner
Molding Finished
edge against piece
guide fence
Ceiling Finished
contact edge piece will be
should be on the Left
against guide side of blade.
fence.
Wall contact
edge should
Finished
be against
piece will be
guide fence.
on the Right
Ceiling side of blade.
contact edge
should be
against guide
fence.
(c) (d)
1 2
Miter angle
45° type 52/38°
type
Right Right
30° 31.6°
Left
31.6°
Right
31.6°
Table (B)
–
For inside
corner
For outside
corner
Example:
In the case of cutting 52/38° type crown molding for
position (a) in the above figure:
• Tilt and secure bevel angle setting to 33.9° RIGHT.
• Adjust and secure miter angle setting to 31.6°
RIGHT.
• Lay crown molding with its broad back (hidden)
surface down on the turn base with its WALL
CONTACT EDGE against the guide fence on the
saw.
• The finished piece to be used will always be on
the RIGHT side of the circular saw blade after the
cut has been made.
45° type
Right
35.3°
Left
35.3°
Right
35.3°
26 ENGLISH
Molding Molding
position in edge against
the figure guide fence
(a) Wall contact
edge should
be against
guide fence.
(b) Ceiling
contact edge
(c)
should be
against guide
fence.
(d) Wall contact
edge should
be against
guide fence.
Finished
piece
Finished
piece will be
on the Right
side of blade.
Finished
piece will be
on the Left
side of blade.