Technical Data; Regulatory Information - Interlogix ATS1110-N Manual De Instalación

Menu 7, Security Mode (ATS1115-N / ATS1116-N only)
This option selects the type of user card the ATS1115-N and
ATS1116-N reader will recognise. The reader will recognise
configuration and default cards in both modes. The possible
modes are as follows:
•
Unsecured Mode (default setting): The reader will
recognise blank or un-programmed cards only, by using
the card's unique serial number. The four-byte security
password is not used. Unsecured mode requires the use
of an expanded memory system.
•
Secured Mode: Only cards programmed on the
ATS1620/1621/1622 programmer will be recognised in
this mode. The four-byte security password is used.
Menu 8, Valid Card Flash (ATS1115-N / ATS1116-N only)
This option enables (default setting) and disables the blue LED
flash when a valid card is badged on an ATS1115-N or
ATS1116-N reader.
Menu 9, Protocol options (ATS1115-N / ATS1116-N only)
This option selects the method by which an ATS1115-N /
ATS1116-N reader sends data to the panel. The options are as
follows:
•
Wiegand: Smart Card data is transmitted in the Wiegand
protocol by default. The ATS1620/1621/1622 programmer
sets the number of bits (26- or 27-bit) when user cards are
programmed.
•
Magnetic Stripe: The reader sends data to the panel in
a 32-bit magnetic stripe card format.
•
Tecom Smart Card: This format is not implemented in the
panel and should not be selected.
Menu 10, Card Beep Options (ATS1115-N / ATS1116-
N only)
This option enables the beep sounded when a card is badged
on the reader (default setting) and disables the beep.
Menu 11, Option Card (ATS1115-N / ATS1116-N only)
This option enables (default setting) and disables the use of
reader configuration (option) cards at the ATS1115-N and
ATS1116-N reader. If an installer wishes to prevent the
modification of the reader setup by configuration card, this
option should be disabled.
Menu 12, Last Card (ATS1115-N / ATS1116-N only)
This option displays the number of the last card badged on an
ATS1115-N or ATS1116-N reader, in the format: Facility Code
/ System Code, ID Number or as raw card data (depends on
setting of security mode).

Technical data

Supply voltage
Maximum operating current
Normal operating current (all
areas armed)
P/N 466-2915 (ML) • REV B • ISS 14MAY18
ATS1110-N ATS1115-N
ATS1111-N ATS1116-N (with
smart card reader)
8.5 to 14.0 V
95 mA at 165 mA at 13.8 V
13.8 V
35 mA at 13.8 V
26 mA at
13.8 V
Open collector output ("OUT"
terminal)
Wireless operating frequency
Maximum power output
Dimensions with cover
(W x H x D)
Weight
Operating temperature
Humidity
Code combinations:
5 digits
9 digits
IP rating
ACE type (tamper protection)

Regulatory information

Manufacturer UTC Fire & Security Americas Corporation, Inc.
3211 Progress Drive, Lincolnton, NC, 28092, USA
Authorized EU manufacturing representative:
UTC Fire & Security B.V.
Kelvinstraat 7, 6003 DH Weert, Netherlands
Product warnings THESE PRODUCTS ARE INTENDED FOR
and disclaimers SALE TO AND INSTALLATION BY QUALIFIED
PROFESSIONALS. UTC FIRE & SECURITY
CANNOT PROVIDE ANY ASSURANCE THAT
ANY PERSON OR ENTITY BUYING ITS
PRODUCTS, INCLUDING ANY "AUTHORIZED
DEALER" OR "AUTHORIZED RESELLER", IS
PROPERLY TRAINED OR EXPERIENCED TO
CORRECTLY INSTALL FIRE AND SECURITY
RELATED PRODUCTS.
For more information on warranty disclaimers and
product safety information, please check
https://firesecurityproducts.com/policy/product-
warning/
Version This document applies to ATS111x-N firmware
version 10 or later.
Certification
EN 50131-1 System requirements
EN 50131-3 Control and indicating equipment
Security Grade 3, Environmental class II
Tested and certified by Telefication B.V.
ATS1110-N, ATS1111-N: UTC Fire & Security
hereby declares that this device is in compliance
with the applicable requirements and provisions of
the Directive 2014/30/EU and/or 2014/35/EU. For
more information see
www.utcfssecurityproducts.eu
ATS1115-N, ATS1116-N: UTC Fire & Security
hereby declares that this device is in compliance
with the applicable requirements and provisions of
all applicable rules and regulations, including but
not limited to the Directive 2014/53/EU. For more
information see www.utcfssecurityproducts.eu
ATS1110-N ATS1115-N
ATS1111-N ATS1116-N (with
smart card reader)
15 V max. at 50 mA max.
—
125 kHz
—
65.7 dBµA/m
at 10 m
92 x 165 x 25.4 mm
(3.6 x 6.5 x 1 in.)
300 g 305 g
−10 to +50°C (22 to 122°F)
< 95% non condensing
100 000
1 000 000 000
IP30
B
or scan the QR code.
5 / 52