Threading The Machine (3 Threads) - Janome 3434D Manual De Instrucciones

2
1
56

Threading the Machine (3 threads)

Using the needle on the right only
(for regular three-thread serging)
Turn off the power switch and unplug the machine.
Remove the needle and the thread on the left. Then
retighten the needle clamp screw on the left to
prevent losing the screw.
1
Using the needle on the left only
(for wide three-thread serging)
Turn off the power switch and unplug the machine.
Remove the needle and the thread on the right.
Then retighten the needle clamp screw on the right
to prevent losing the screw.
2
To replace bent or blunt needles in three-thread
serging
Loosen both needle clamp screws and remove the
needle. Insert the needle and tighten the needle
clamp screw for the needle to be used while pushing
the needle up as far as it will go.
Then tighten the needle clamp screw on the other
side slightly to prevent losing the screw.
1
Needle on the right
2
Needle clamp screw on the left
1 Needle on the left
2 Needle clamp screw on the right