Balluff BML-M30-I 0-A0-M122/090-R Serie Instrucciones Breves página 3

BML-M30-I _ 0-A0-M122/090-R _
Reference Body – Magnetic Ring
Dimensions
Optical reference point marking
BML-M30-I_0-A0-M122/090-R_ dimensions
User's guide download
A complete user's guide can be downloaded from the
Internet at www.balluff.com/downloads-bml or
requested via e-mail from service@balluff.de.
Installation
Longitudinal installation/travel direction
Tangential offset
Transverse direction of installation/travel
Tangential
offset
Distances between the sensor head and reference body
www.balluff.com
The magnetic rings can be used with the following sensor
heads:
Note: The sensor head for the BML-...-R1 magnetic ring
must be equipped with a reference point sensor. Sensor
heads BML-S1A, BML-S1B, BML-S1C, BML-S1E may not
be used.
The following distances and tolerances must be strictly
observed when installing the sensor head and magnetic
Transverse
ring.
offset
The dimensions can be found in the respective user's
guide for the sensor head:
–
–
–
–
–
–
Transverse offset
Legend:
1 Incremental sensor
2 Area without magnetizable material
3 Reference point sensor
4 Reference point marking
Technical data
...-I30-...
Pole width 1 mm
No. of poles 384
Material Stainless steel with elastomer coating
BML-...-R0
With reference No
point
Suitable sensor heads
BML- BML-
M30-I30-... M30-I40-...
1 mm System 5 mm System
BML-S_F...-M3... BML-S_B...-M4...
BML-S_C...-M4...
BML-S_E...-M4...
Gap between the sensor head and reference body
Transverse offset between the sensor head and
reference body
Tangential offset between the sensor head and
reference body
Permissible angular tolerances
Position of the reference point sensor/incremental
sensor
Area in which no magnetizable material may be used
...-I40-... ...-I50-...
5 mm 2 mm
76 192
BML-...-R1
Yes
BML-
M30-I50-...
2 mm System
BML-S_F...-M5...
english 1