Zenoah GZ360 Manual De Usuario página 10

• Always move the product at least 3 m (10 ft) away
from the refuelling area and source before starting.
After refuelling, there are some situations where you
must never start the product:
• If you have spilled fuel or chain oil on the product.
Wipe off the spillage and allow remaining fuel to
evaporate.
• If you have spilled fuel on yourself or on your
clothes. Change your clothes and wash any part of
your body that has come in contact with fuel. Use
soap and water.
• If the product leaks fuel. Regularly do a check for
leaks from the fuel cap and fuel lines.
Safety instructions for maintenance
Cutting equipment
This section describes how to choose and maintain your
cutting equipment in order to:
• Reduce the risk of kickback.
• Reduce the risk of the saw chain breaking or
jumping off the bar.
• Obtain optimal cutting performance.
• Extend the life of cutting equipment.
• Avoid increasing vibration levels.
WARNING: Read the warning instructions
that follow before you use the product.
• Faulty cutting equipment or the wrong combination
of bar and saw chain increases the risk of kickback!
Only use the bar/saw chain combinations we
recommend, and follow the filing instructions. See
instructions under the heading
41 .
• Always use protective gloves when you handle the
saw chain.
• Any contact with a rotating saw chain can cause
extremely serious injuries.
10
Accessories on page
• Keep the chain's cutting teeth properly sharpened!
Follow our instructions and use the recommended
file gauge. A damaged or badly sharpened chain
increases the risk of accidents.
• Maintain the correct depth gauge setting! Follow our
instructions and use the recommended depth gauge
clearance. Too large a clearance increases the risk
of kickback.
• Keep the chain properly tensioned! If the chain is
slack it is more likely to jump off and lead to
increased wear on the bar, chain and drive sprocket.
• Keep cutting equipment well lubricated and properly
maintained! A poorly lubricated chain is more likely
to break and lead to increased wear on the bar,
chain and drive sprocket.
Some terms that describe the bar and chain
To maintain the safety features of the cutting equipment,
you should replace a worn or damaged bar or chain with
a guide bar and saw chain combinations recommended
by Zenoah. See instructions under the heading
Accessories on page 41 for a list of replacement bar
and chain combinations we recommend.
Guide bar
321 - 004 - 27.09.2017