Cleaning And Maintenance - Baby auto KUDOS fix 123 Manual De Uso

5. Unscrew the nut by turning it. Remove the harness bracket and
store it with the nut and bolt for future use (fig. 5.4 and 5.5).
6. Take the harness strap lock plates from underneath the seat.
Turn them and thread them through the corresponding slots,
removing the straps from the harness. Repeat the same steps
with the fastening strap for the 5-point harness buckle (fig.
5.7, 5.8 and 5.9).
7. Once the harnesses and the belt buckle have been removed,
return the fastener
the chair is locked in place (fig. 5.10).
fastening the child into the seat
1. Place the child seat on the car seat.
2. Sit the child on the seat and then fasten the car seatbelt,
inserting it into the seatbelt buckle until you hear a click (fig.
5.11). Make sure that the abdominal strap goes throughthe
(O)
guide
ensure it is not twisted and tighten it by pulling the diagonal
strap upwards.
3. Thread the diagonal part of the belt through the diagonal belt
guide (M)
it is not twisted.
As the child grows, the headrest height must be adjusted. In
order to do this, the steps outlined in point 4 must be followed.

6. cleanInG anD maIntenance

1. To wash belts and plastic parts, use neutral detergent and
warm water.
2. Ensure that soap does not enter inside the buckle or metal pieces.
3. Do not use chemical products or bleach on any part of
the child seat.
22
(H)
to its position so that the backrest of
behind both armrests (fig. 5.13). Check the strap to
until it is securely in place (fig. 5.14). Make sure that