Skil PWRCORE 20 IF5940-00 Manual Del Propietário página 11

12V d .c . Vehicle Power (Fig .3)
Remove the 12V d.c. vehicle connector from
the sleeve inside the storage compartment
of the 12V d.c. vehicle connector and cord.
Connect the 12V d.c. vehicle connector to your
vehicle's 12V d.c. accessory socket. Always
fully extend the 12V d.c. vehicle cord before
each use.
Wrap the 12V d.c. vehicle cord back into the
storage compartment and insert the 12V d.c.
vehicle connector into the sleeve after each
use for storage.
WARNING
on items to be inflated. Never exceed recommended pressures.
WARNING
NOTICE:
Possible air leaks can cause faulty pressure readings. Make sure all connections
are tightly secured.
Inflating with the High-Pressure
Hose (Fig .4)
The air chuck on the high-pressure hose can
be used without adapters to inflate tires or
other items that have a valve stem that fits the
air-chuck opening.
1. Raise the air-chuck clamp.
2. Place the air chuck on valve stem.
3. Push the air chuck down so that the
threaded section of the valve stem is inside
the air chuck.
4. Clamp the air chuck onto the valve stem by
pressing air-chuck clamp down until it stops
or is parallel to the air hose.
5. See the instructions in the section of "Use the Digital Pressure Gauge in the High-
Pressure Mode" in this manual for using the dual function inflator to start inflation.
The dual function inflator is capable of inflating to 160 PSI ,11 BAR or
1100 kPa max. To avoid over inflation, carefully follow the instructions
Improperly attached hoses or adapters can become detached under
pressure and cause serious injury .
Fig. 3
Sleeve
Storage
Compartment
12V d.c. vehicle connector
Fig. 4
High
Pressure
Hose
12V d.c.
vehicle cord
Air Chuck
Clamp
Air Chuck
Valve Stem
11