Maintenance - Skil PWRCORE 20 IF5940-00 Manual Del Propietário

MAINTENANCE

WARNING
Service
WARNING
cause serious hazard. We recommend that all tool service be performed by a Skil Factory
Service Center or Authorized Skil Service Station.
General Maintenance
WARNING
NOTE: Periodically inspect the entire product for damaged, missing, or loose parts such as
screws, nuts, bolts, caps, etc. Tighten securely all fasteners and caps and do not operate this
product until all missing or damaged parts are replaced. Please contact customer service or
an authorized service center for assistance.
Cleaning
WARNING
Ventilation openings and switch levers must be kept clean and free of foreign matter. Do not
attempt to clean by inserting pointed objects through openings.
WARNING
ammonia and house hold detergents that contain ammonia.
Storage
Store the tool indoors in a place that is inaccessible to children. Keep away from corrosive
agents.
Adapters/Hoses Storage (Fig .1)
12V d .c . Vehicle Connector and Cord
The 12V d.c. vehicle connector can be inserted into the sleeve in the storage compartment
and the 12V d.c. Vehicle cord can be wrapped and stored in the storage compartment.
High-Pressure Hose
The high-pressure hose is located on a storage channel on the left side of the dual function
inflator.
Wrap the high pressure hose inside the channel and secure in the clip on the channel.
High-Volume Hose
The high volume hose is located on a storage channel on the right side of the dual function
inflator. Wrap the high volume hose inside the channel and secure in the two clips on the
channel.
Adaptors
When not in use, adapters provided with the inflator can be placed in the storage area located
on the left side of the housing.
16
To avoid serious personal injury, always remove the battery pack
from the tool when cleaning or performing any maintenance .
Preventive maintenance performed by unauthorized personnel may
result in misplacing of internal wires and components which could
When servicing, use only identical replacement parts. Use of any other
parts could create a hazard or cause product damage.
The tool may be cleaned most effectively with compressed dry air. Always
wear safety goggles when cleaning tools with compressed air .
Certain cleaning agents and solvents damage plastic parts . Some of
these are: gasoline, carbon tetrachloride, chlorinated cleaning solvents,