Skil PWRCORE 20 IF5940-00 Manual Del Propietário página 14

Deflating with the High-Volume Hose
1. Remove the high-volume hose from its
storage area.
2. Insert the high-volume hose fully into the air
intake (Fig.10).
3. Connect other end of the hose to the item to
be deflated. Connect the hose directly or use
the adapter attached to the hose.
4. See the instructions in the section of "Use the
Digital Pressure Gauge in the High-Volume
Mode" in this manual for using the dual
function inflator to start deflation.
5. After deflation, remove the high volume hose
from the air intake.
Using the Dual Function Inflator
Use the Digital Pressure Gauge in the
High-Pressure Mode (Fig .11)
1. Attach the battery pack onto the dual
function inflator or connect the 12V d.c.
vehicle connector to your vehicle's 12V d.c.
accessory socket.
2. Turn the digital pressure gauge on by
pushing the power button. The working
mode will default to the high-pressure mode
. The dual function inflator will detect the
current air pressure of the item.
3. Use the and
pressure, if desired. Press and hold
buttons to move down or up more quickly.
NOTE: If the current pressure item to be inflated is greater than the target pressure, the dual
function inflator will not begin inflation.
4. To select the desired unit of pressure, press the
scroll through the units of PSI, BAR and kPa.
5. To start or pause the inflation, press the start/pause button.
6. The dual function inflator will shut off automatically when the target pressure has been
reached.
CAUTION
NOTE: The dual function inflator will shut down after 5 minutes of inactivity.
14
buttons to set the target
Allow the dual function inflator to cool for 5 minutes after each 15 minutes
of continuous use.
Fig. 10
High-Volume
Hose
Fig. 11
Target Input Value
Actual Value
or
and
High-Pressure Mode
buttons simultaneously to
Unit Applied