Setting The Date And Time - Medisana BU 550 CONNECT Instrucciones De Manejo

WARNING - BATTERY SAFETY INFORMATION
• Only replace with batteries of the same type, never use different types of
batteries together or used batteries with new ones!
• Insert the batteries correctly, observing the polarity!
• Remove the batteries from the device if it is not going to be used for an
extended period!
• Keep batteries out of children's reach!
• Do not attempt to recharge these batteries! There is a danger of
explosion!
• Do not short circuit! There is a danger of explosion!
• Do not throw into a fire! There is a danger of explosion!
• Do not throw used batteries into the household refuse; put them in a
hazardous waste container or take them to a battery collection point, at
the shop where they were purchased!
3.2 Using a Mains Adaptor
Alternatively, you can use the unit with a special mains adaptor (MEDISANA Art.-No.
51013. This connects to the socket
the batteries remain in the unit. Inserting the connector into the back of the blood pres-
sure monitor switches the batteries off mechanically. It is necessary, therefore, to plug
the mains adaptor into the mains socket first of all and then to connect it to the blood
pressure monitor. If the blood pressure monitor is no longer being used, first remove
the connector from the blood pressure monitor and then pull the mains adaptor out of
the mains socket. Doing this means that the date and time will not have to be reset
each time.

3.3 Setting the date and time

1. Before using the unit, you need to put the LOCK-switch
In "OFF" (red) - position the Bluetooth function is deactivated and all buttons are
locked.
2. Press and hold the S-button
3. Firstly, the date figure starts to flash. Press M-button
4. Press the S-button
5. Now the day figure starts flashing. Proceed accordingly for the input of day, year,
hour and minute (as described under point 3 and 4).
6. On completion of the date and time setting, "Ok" appears on the display. The unit
switches off automatically after about 60 seconds, if no buttons are pressed in order
to save power.
3.4 Setting up the user memory
The MEDISANA Upper arm blood pressure monitor BU 550 connect gives you the
opportunity to assign readings to one of two user memories, each of which provides
500 memory slots. Press and hold the M-button
symbol for User 1
User 1 and User 2 or Guest
not be saved.
Press the S-button


for at least 3 seconds.

to confirm the setting.
appears in the display. By pressing M-button
. If you choose "Guest", the values of the reading will

to confirm your selection.
3 Getting started
provided at the back of the unit. In this case


to adjust the actual month.

for at least 3 seconds, until the
to position "ON" (green).

you can switch
GB
i
i
i
i
i
23