Pc Adjustment - Eiki LC-XNB2 Manual De Instrucciones

COMPUTER MODE
This Projector can automatically tune to the display signals from most personal computers currently distributed.
However, some computers employ the special signal formats which are different from the standard ones and
may not be tuned by Multiscanning of this projector. If this happens, the projector cannot reproduce a proper
image and the image is recognized as a flickering picture, a non-synchronized picture, a non-centered picture or
a skewed picture.
This projector has PC ADJUSTMENT function, to enable you to precisely adjust several parameters to match
with those exceptional signal formats and the projector has five independent memory areas to memorize those
parameters manually adjusted. This enables you to recall the setting for a specific computer whenever you use
it.
Press the MENU button and the ON-SCREEN MENU will
1
appear. Press the POINT RIGHT/LEFT buttons to select PC
ADJUST
box "Where to reserve" Menu will appear.
2 In this dialog box, you can store the parameter into the area
from "Mode 1" to "Mode 5." When memorizing the new
computer parameter, select the Mode with the message of
"Free" by pressing the POINT UP/DOWN buttons and the
SELECT button. To change the parameters of the Mode
previously set, select the Mode with "Stored."
When the Mode is selected, Parameter adjustment dialog box
3
appears. Move the arrow to the item that you want to change
by pressing the POINT UP/DOWN buttons, and adjust the each
item to match with your computer. To change the value, press
either the POINT RIGHT button or the POINT LEFT button.
Refer to the next page for adjusting each item.
4 Move the arrow to "Stored" and press the SELECT button. The
parameter is memorized in the selected Mode.
To activate the Mode manually adjusted in this PC
5
ADJUSTMENT Menu, select the Mode at the SYSTEM
SELECT Menu. (Refer to page 23.)
GB
24

PC ADJUSTMENT

and press the SELECT button. Another dialog
This Mode has para-
meters being stored.
The Vacant Mode.
Manual set Computer
Mode (1 to 5).
Close the PC
ADJUSTMENT Menu.
Press the POINT
RIGHT/LEFT
button(s) to
adjust the value.
Press the
SELECT button
to set Full screen
function on/off.