Maintenance & Adjustments; Checking & Replacing Carbon Brushes - Evolution R185CCSL Instrucciones Originales

www.evolutionpowertools.com
MAINTENANCE & ADJUSTMENTS
(18)
CCS series
The 0 (blade vertical) position can be adjusted.
0
WARNING: The machine must be disconnected from the mains
power supply when attempting this procedure.
To check 0 position:
0
• Set the blade to the 0 position with the tilting mechanism
0
against its stop.
• Check the blade against the sole plate using an engineers
precision square (not supplied). Take care to avoid the TCT tips
of the teeth. The blade should be at exactly 90
Note: The lower blade guard should be rotated (manually) up
into the upper blade guard. This will help accurate positioning
of the engineers square and thus aid the checking process.
If adjustment is required:
CCSL
Turn the adjustment screw (Fig. 16) clockwise or counter
clockwise using a Hex Key (not supplied) until the blade is at
exactly 90 to the sole plate.
0
CHECKING AND REPLACING
(19)
THE CARBON BRUSHES
WARNING: Disconnect the machine from the power supply
before attempting to check or replace the Carbon Brushes.
Note: Replace both carbon brushes if either has less than 6mm
length of carbon remaining, or if the spring or wire is damaged
or burned.
To remove the brushes:
• Unscrew the plastic caps found at the back of the motor
housing. (Fig. 17) Be careful as the caps are spring-loaded.
• Withdraw the brushes with their springs.
• If replacement is necessary renew the brushes and replace
the caps.
Note: Used but serviceable brushes can be replaced, but only
as long as they are returned to the same position, and
inserted the same way round as they were before being
removed from the machine.
• Run machines motor without load for approximately 5
minutes. This will help the new brushes to 'bed-in' and
ensure that the motor runs efficiently.
• Some sparking may be visible until the brushes bed in fully.
Fig. 16
to sole plate.
0
Fig. 17
19