Rs232 Interface; Rs232 Interface Connector; Single Instrument Rs232 Connections; Addressable Rs232 Connections - TTI QL Serie Manual De Instrucciones

RS232 Interface

RS232 Interface Connector

The 9-way D-type serial interface connector is located on the instrument rear panel. The pin
connections are as shown below:
Pin
1
2
3
4
5
6
7
8
9

Single Instrument RS232 Connections

For single instrument remote control only pins 2, 3 and 5 are connected to the PC. However, for
correct operation links must be made in the connector at the PC end between pins 1, 4 and 6 and
between pins 7 and 8, see diagram. Pins 7 and 8 of the instrument must not be connected to the
PC, i.e. do not use a fully wired 9–way cable.
Baud Rate is set as described above in Address and Baud Rate Selection; the other parameters are
fixed as follows:
Start Bits: 1
Data Bits: 8

Addressable RS232 Connections

For addressable RS232 operation pins 7, 8 and 9 of the instrument connector are also used.
Using a simple cable assembly, a 'daisy chain' connection system between any number of
instruments, up to the maximum of 32 can be made, as shown below:
The daisy chain consists of the transmit data (TXD), receive date (RXD) and signal ground lines only.
There are no control/handshake lines. This makes XON/XOFF protocol essential and allows the
inter-connection between instruments to contain just 3 wires. The wiring of the adaptor cable is
shown below:
32
Name Description
- No internal connection
TXD Transmitted data from instrument
RXD Received data to instrument
- No internal connection
GND Signal ground
- No internal connection
RXD2 Secondary received data (addressable RS232 only)
TXD2 Secondary transmitted data (addressable RS232 only)
GND Signal ground (addressable RS232 only)
Parity: None
Stop Bits: 1