Publicidad
INSTRUCTIONS / INSTRUCCIONES / INSTRUCTIONS
1.
Back of
Base
Place the base on the ground. Remove
all FOUR clip hooks (F) located on cargo
carrier. You will reinstall them on the
cargo carrier in steps #2, #3 & #7.
2.
3 Tabs
Place the lid onto the base at approximately a
30° angle. Move top lid in an up and down motion
until THREE hinge tabs engage with slots.
Close up of a hinge tab fully engaged.
IMPORTANT!
4
Front of Base
On the back of the lid, locate key and turn it to
be parallel with the ground to "unlock" and then
remove the key (key will be needed in step #8).
Clip hooks
When lid is aligned, all 3 hinge tabs will slide
4.
Check clearance area
Fully Engaged
Unlocked
Fully Engaged
down into the slots as shown above.
Hinge tabs NOT fully engaged.
Insert one clip hook
through center hinge
tab hole to secure.
Locked
NOT Fully
Engaged
Publicidad
