Publicidad
INSTRUCTIONS / INSTRUCCIONES / INSTRUCTIONS
5.
Lift the back of the cargo carrier lid to
Raise the TWO uprights and place into locked
approximately 30° as shown above.
position on the bracket as shown.
6.
Mounting Bracket
Mounting Plate
Place the mounting bracket (A) through the
Then slide the mounting plate (C) over the
pre-drilled holes from below the vehicle
threaded posts inside the cargo carrier.
4.
cross rails as shown above.
Check clearance area
Knobs
Thread two knobs (B) evenly and loosely – do not tighten all the way at this
point. Repeat steps until all 4 mounting brackets (A), all 4 mounting plates
(C) are in place and the 8 knobs (B) are loosely in place. Make sure cargo
carrier is centered on vehicle. Then tighten all 8 knobs evenly and securely.
6
Publicidad
