Puky Laufrad Alu Manual De Instrucciones página 10

Learning bike Loopfiets
Figure 6: Now centre the brake arms by turn-
ing the adjusting screw. You will need a cross-
tip screwdriver for this.
It is important that the brake levers are
actuated several times so that the tension
of the brake arms is evenly distributed to
both sides and the settings take effect. The
brake/rim contact must be identical on both
sides.
Figure 7: To adjust the height of the handle-
bar, first loosen both screws on the handlebar
(1). Then fully unscrew the cap screw (2) and
pull the handlebar and the two spacer rings in
an upward direction. The spacer rings can be
positioned individually above or below the han-
dlebar. To fasten, proceed in reverse order.
Please make sure that you do not lose any
parts of the headset and that the handlebar
is mounted in the right direction.
43817_pu_bda_laufrad_alu_148x210.indd 10
Figure 8: After loosening the saddle clamp,
you can pull out the saddle (observe minimum
insertion depth!).
Then retighten (5-8 Nm).
Figure 9: When tightening the screw beneath
the bike, the suspension effect of the elasto-
mer may be slightly reduced (more rigid). This
suspension becomes more flexible when un-
tightening.
When adjusting, please make sure that
there is no play between the swing arm and
the screw.
10
24.10.2018 15:11:40