Dremel 4000 Instrucciones De Funcionamiento Y Seguridad página 10

1600A012FM.qxp_4000 1/30/17 10:01 AM Page 10
COLLET
WRENCH
TO
TIGHTEN
COLLET NUT — To loosen, first press shaft
lock button and rotate the shaft by hand until the
lock engages the shaft preventing further
rotation. Your Dremel 4000 is equipped with a
quick collet lock mechanism. This mechanism
engages the output shaft in 8 separate locations
on the shaft for easier operation.
With the shaft lock engaged use the collet
wrench to loosen the collet nut if necessary. The
collet nut must be loosely threaded on when
inserting an accessory. Change accessories by
inserting the new one into the collet as far as
COLLETS — Four different size collets (see
illus tration), to accommodate different shank
sizes, are avail able for your Rotary Tool. To
install a different collet, remove the collet nut
and remove the old collet. Insert the unslotted
480
1/8"
COLLET
COLLET
NUT
481
3/32"
COLLET
10
Assembly
Always unplug Rotary Tool before changing accessories, changing
collets or servicing your Rotary Tool.
SHAFT LOCK
BUTTON
COLLET
TO
NUT
LOOSEN
Do not engage lock while
the Rotary Tool is running.
IDENTIFICATION
RINGS
483
482
1/32"
1/16"
COLLET
COLLET
SHAFT LOCK
BUTTON
COLLET
NUT
TO TO
possible to minimize runout and unbalance. TIGHTEN LOOSEN
With the shaft lock engaged, finger tighten the
collet nut until the accessory shank is gripped by
the collet. Avoid excessive tightening of the
collet nut when there is no bit inserted.
EZ TWIST™ INTEGRATED
WRENCH/NOSE CAP
The nose cap of your tool has an integrated
wrench allowing you to loosen and tighten the
collet nut without the use of the standard collet
wrench. Unscrew the nose cap from the tool,
line-up steel insert on inside of cap with collet
nut. With the shaft lock engaged twist nose cap
clockwise to tighten, and counter-clockwise to
loosen.
end of the collet in the hole in the end of the
tool shaft. Replace collet nut on the shaft.
Always use the collet
which matches the shank
size of the accessory you plan to use. Never
force a larger diameter shank into a collet.
Note: Most rotary tool kits do not include all
four collets sizes.
COLLET IDENTIFICATION CHART
Collet sizes can be identified by the rings
on the back end of collet.
1/32" Collet has one (1) ring.
1/16" Collet has two (2) rings.
3/32" Collet has three (3) rings.
1/8" Collet has no rings. (Included in
most tool kits on the tool)
EZ TWIST™
INTEGRATED
WRENCH/NOSE CAP