Connections To Be Made - Axxess BX-GM5 Instrucciones De Instalación

Applications
BUICK
Express 2008-up *
Impala Limited 2014
Enclave 2008-up
Impala 2006-2013
Lucerne 2006-2011
Monte Carlo 2006-2007
CADILLAC
Silverado 2500/3500
DTS 2006-2011 ∆
2014 * †
Escalade 2007-2011 ∆
Silverado (new body)
Escalade ESV 2007-2011 ∆
2007-2013 * †
Escalade EXT 2007-2011 ∆
Suburban 2007-2014 * †
SRX 2007-2009 ∆
Tahoe 2007-2014 * †
Traverse 2009-up
CHEVROLET
Avalanche 2007-2013 * †
GMC
Captiva Sport 2012-2014
Acadia 2007-up
Equinox 2007-2009 Savanna 2008-up *
* If the vehicle comes equipped with factory navigation in the 2012 and up models, you
must use either the GMOS-LAN-08 for non-amplified models, or GMOS-LAN-07 for
amplified models, along with the ASWC-1.
† These vehicles have a digital amp option. Refer to the "Service Parts Identification" sticker
located in the glove box. Vehicles with STZ, UQS, and/or Y91, have a digital amp option.
∆ Indicates vehicle is standard for a digital amplifier.
BX-GM5
Sierra 2500/3500 2014 * †
From the 16-pin harness with stripped leads to the aftermarket radio:
Sierra (new body)
• Connect the (2) Red wires to the accessory wire.
2007-2013 * †
Yukon 2007-2014 * †
HUMMER
• Connect the Blue/White wire to the amp turn on wire. (This wire must be
H2 2008-2009 ∆
PONTIAC
• Connect the Orange/White wire to the illumination wire. (If the aftermarket
Torrent 2007-2009
Saturn
• Connect the Brown wire to the mute wire. (If the aftermarket radio has no mute
Outlook 2007-2010
Vue 2008-2010
• Connect the White wire to the left front positive speaker output.
SUZUKI
• Connect the White/Black wire to the left front negative speaker output.
XL-7 2007-2009
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative speaker output.
2

Connections to be made

Note: If installing the AX-LCD (sold separately), there will be an accessory wire
there to connect as well.
connected to hear sound from the factory amplifier.)
radio has no illumination wire, tape off and disregard this wire).
wire, tape off and disregard this wire).
Only make the following (4) connections if the vehicle comes equipped
with a digital amplifier:
Continued on the next page