Connections To Be Made - Axxess AX-ADFD100 Instrucciones De Instalación

Applications
LD-AX-ADFD01
FORD
Econoline (without NAV) 2014
Edge 2007-2010
Escape 2008-2012
Expedition 2007-2014
Explorer 2008-2010
Explorer Sport Trac 2008-2010
F-150 2009-2012
F-250/350/450/550 2011-2012
Focus 2008-2011
Fusion 2008-2012
Mustang 2010-2014
Taurus 2008-2012
(w/ Sync or Sony)
Taurus X 2008-2009
(w/ Sync or Sony)
LINCOLN
MKX 2007-2010
MKZ 2007-2009
Navigator 2007-2014
MERCURY
Mariner 2008-2011
Milan 2008-2011
Mountaineer 2008-2010
Sable 2008-2009
(with Sync or Sony)
AX-ADFD100

Connections to be made

LD-AX-ADFD01 vehicle applications
From the 16-pin harness to the aftermarket radio:
• Connect the (2) Red wires to the ignition wire.
• Connect the Orange/White wire to the illumination wire. If the aftermarket radio
does not have an illumination wire, tape off the Orange/White wire.
• Connect the Blue/White wire to the amp turn on wire.
• Connect the Brown wire to the mute wire. If the aftermarket radio
does not have a Mute wire, tape up the Brown wire.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
Only make the following connections if the vehicle contains the SONY/THX amplified system.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative speaker output.
Continued on next page
2