Installing Or Removing The Blade - Makita XBP01 Manual De Instrucciones

Sierra de banda portátil inalámbrica
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Release the switch trigger to stop. After use, always
press in the trigger-lock button from A side.
Lighting up the lamp
CAUTION:
Do not look in the light or see the source of light
directly.
1
014548
Pull the switch trigger to light up the lamp. The lamp
keeps on lighting while the switch trigger is being pulled.
The lamp goes out just after releasing the trigger.
NOTICE:
Do not apply impact to the lamp, which may cause
damage or shorted service time to it.
Use a dry cloth to wipe the dirt off the lens of lamp.
Be careful not to scratch the lens of lamp, or it
may lower the illumination.
Do not use thinner or gasoline to clean the lamp.
Such solvents may damage it.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
battery cartridge is removed before carrying out
any work on the tool.

Installing or removing the blade

CAUTION:
Oil on the blade can cause the blade to slip or
come off unexpectedly. Wipe off all excess oil with
a cloth before installing the blade.
Always wear protective gloves when handling the
blade.
Use caution when handling the blade to avoid cut
by the sharp edge of the blade teeth.
Keep your body away from the blade area when
checking the blade movement.
When turning the blade tightening lever clockwise
to release the tension on the blade, point the tool
downward because the blade may come off
unexpectedly.
1. Lamp
NOTICE:
When opening the wheel cover, press and open both
the stoppers simultaneously. Opening only one stopper
may cause crack on the wheel cover.
1
014579
1
2
014189
To install the blade:
1.
Open the wheel cover.
2.
Turn the blade tightening lever clockwise until it
stops to loosen the wheel.
3.
Match the direction of the arrows on the blade
and on the wheels.
2
014190
1
014236
4.
Insert the non-serrated side of the blade into the upper
holder and lower holder. Make sure the blade in both
upper and lower holder touches to the bottom bearings.
6
1. Wheel cover
1. Tighten
3
2. Loosen
3. Lever
1. Lower holder
1
2. Upper holder
1. Bottom bearing

Publicidad

Tabla de contenido
loading

Tabla de contenido