Speed Adjusting Dial; Installing Or Removing The Blade - Makita 2107F Manual De Instrucciones

Speed adjusting dial

005896
The tool speed can be infinitely adjusted between 1.0
m/s and 1.7 m/s by turning the adjusting dial. Higher
speed is obtained when the dial is turned in the direction
of number 5; lower speed is obtained when it is turned in
the direction of number 1.
Select the proper speed for the workpiece to be cut.
CAUTION:
The speed adjusting dial can be turned only as far
•
as 5 and back to 1. Do not force it past 5 or 1, or the
speed adjusting function may no longer work.
Lighting up the lamps
005897
CAUTION:
Do not apply impact to the light, which may cause
•
damage or shorted service time to it.
To turn on the lamp, press the "I"(ON) side of the lamp
switch. Press the "O"(OFF) side to turn it off.
NOTE:
Use a dry cloth to wipe the dirt off the lens of lamp.
•
Be careful not to scratch the lens of lamp, or it may
lower the illumination.
Do not use thinner or gasoline to clean the lamp.
•
Such solvents may damage it.
After operation, always turn off the light by pressing
•
the "O (OFF)" side.
1. Speed adjusting
1
dial
1. Lamp switch
1
Hook (Optional accessory)
006190
The tool may be hung using the hook. Hang tool on a
pipe vice or other suitable, stable structure.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the tool.

Installing or removing the blade

CAUTION:
Oil on the blade can cause the blade to slip or come
•
off unexpectedly. Wipe off all excess oil with a cloth
before installing the blade.
Use caution when handling the blade so that you
•
are not cut by the sharp edge of the blade teeth.
Turn the blade tightening lever clockwise until it hits
against the protrusion on the frame.
4
1
3
006191
Match the direction of the arrow on the blade to that of
the arrow on the wheels.
1
3
006192
Position the blade around the wheels and insert the other
side of the blade within the upper holder and lower holder
until the blade back contacts the bottom of the upper
5
1. Hook
1
1. Tighten
2. Loosen
2
3. Protrusion
4. Lever
1. Blade
2. Bearing
4
3. Upper holder
4. Lower holder
2