K2 Pumps WPS05004K El Manual Del Propietario página 5

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLATION
Flexible pipe is prohibited on suction pipe (inlet pipe). Unions or hose couplings can be installed near pump to
facilitate removal for servicing or storage. A rubber hose installed between the water system and the house piping will
reduce the noise transmitted to the house.
1. INSTALLING PIPING IN WELL
CAUTION: Dry-fit entire assembly to ensure proper fit before gluing or taping parts. Follow all proper gluing procedures
as specified by the glue manufacturer. Always glue in a vertical direction whenever possible to prevent glue from dripping
inside pipe or fittings Use pipe tape and pipe paste compound on all male threads. Tighten with wrench to a snug fit and
add another 1/4 turn to ensure proper seal.
For Cased well Installation
1. Connect 1-1/4in. Brass Foot Valve to 1-1/4in.PVC
MPT×S Male Adapter.Cement adapter to 1-1/4 in.
PVC rigid Pipe.All connections must be air- and
water-tight for pump to operate correctly. (Fig 1)
For Professional Technical Support call 1-844-242-2475
2. WELL POINT (DRIVEN POINT) APPLICATION (Fig.2)
Pipe with a pointed screen is driven into the ground below the water
table. The depth is usually less than 25 feet. Available diameters are 1"
through 2.
3. APPLICATION FOR SURFACE WATER (Fig.3)
One pipe goes into lake, river, cistern or ponds,suction lift is less than
25'.
Install a screen around the inlet pipe to prevent the entrapment of
swimmers, wildlife and debris.
CAUTION: Possible contamination. Do not use surface water for
drinking. The installation shown could be used for sprinkler applications.
2. Install well seal over 1-1/4 in. PVC rigid Pipe and
into well casing. Position the foot valve 5 feet above
bottom of well and at least 10 feet below the well's
water level. (Fig 2)
5

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Wps07504k

Tabla de contenido