Berner B 3000 H Manual De Uso Y De Mantenimiento página 16

1. Preface
2. General description
3. Preparation before starting
4. Using the generating set
5. Safety features (if fitted, see specifications table)
6. Maintenance schedule
1. Preface
1.1. Recommendations
Warning
The information contained in this manual is taken from technical data available at the time of print. In line with our policy of continually
improving the quality of our products, this information may be amended without warning.
1.2. Pictograms and plates on the generating sets and what they mean
Danger
Earth
1 2
A = Generating set model
B = Generating set output
C = Voltage
D = Amperage
E = Current frequency
F = Power factor
1.3. Instructions and safety regulations
Do not run the generating set without having put back the protective covers and closed the access doors.
Never take the protective covers off or open the access doors if the generating set is running.
Danger
1.3.1 Warnings
You are likely to encounter several warning symbols in this manual.
This symbol indicates a definite risk to a person's health and life. Failure to follow the corresponding
instruction poses serious risks to the health and life of those concerned.
Danger
This symbol draws attention to the potential risk to a person's health and life. Failure to follow the corresponding
instruction may pose serious risks to the health and life of those concerned.
Warning
This symbol indicates a dangerous situation if the warning is not heeded.
Failure to follow this instruction could result in less serious injury or damage.
Important
Read this manual carefully before use.
The safety advice and the usage and maintenance instructions for the generating set must always
be strictly adhered to.
Danger:
risk of electric shock
Danger: risk of burns
1 - Warning: refer to the documentation accompanying the generating set.
2 - Warning: emission of toxic exhaust gases. Do not use in a confined or poorly
ventilated area.
3 - Stop the motor before filling with fuel.
3
Example of an identification plate
Contents
7. Maintenance procedures
8. Storing the generating set
9. Troubleshooting
10. Specifications
11. Cable sizes
12. EC Declaration of conformity
Danger: the generating set is
supplied without oil.
Before starting the generating
set always check the oil level.
G = Protection rating
H = Generating set noise output
I = Generating set weight
J = Reference Standard
K = Serial number