Cable Gland - Minebea Intec PR 6021/18 Manual De Instalación

4 Installation and connection information
4.3

Cable gland

Minebea Intec
Supply - blue
Screen yellow
Corner adjustment
The cable glands each have one sealing ring.
The M20 cable gland can be itted with a reduction sealing ring if cables ≤8 mm are used
(see Chapter 4.5).
The M25 cable gland must be itted with a four-seal insert to be able to feed in up to four
load cell cables.
The cable wires are connected to the terminals inside the device.
NOTICE
Property damage is possible.
If a seal insert is not used, it must be sealed with a supplied locking pin.
NOTICE
Property damage is possible.
Regularly check the itted cable gland for tightness and re-tighten it, if necessary.
Weighbridge Cable Junction Box PR 6021/18
Terminal contacts - supply voltage (load cells)
1–8
Terminal contact - supply voltage (connection cable)
IND
Terminal contact S - sense (connection cable – black)
Terminal contacts 1 Screen (connection cable)
and Br
Terminal contacts Screen (load cells)
Br and 1–8
Potentiometer 1–8 Trimmer potentiometer for corner correcti-
on
EN-11