4.4 Attaching The Cable Gland - Minebea Intec PR 6021/18 Manual De Instalación

Weighbridge Cable Junction Box PR 6021/18

4.4 Attaching the cable gland

EN-12
1. Remove the parts from the packaging.
2. Slide the sealing ring (3) over the thread of the cable gland (2).
3. Screw the cable gland (2) into the cable junction box and tighten at the hex.
Note:
It is essential that the following tightening torques are observed:
M20: 4 Nm
M25: 6 Nm
4. Screw the cap nut (1) onto the cable gland and tighten slightly.
4 Installation and connection information
Minebea Intec