ASBER T-OEM-350 Instrucciones De Instalación, Uso Y Mantenimiento página 37

EN
Quick guide
G-OEM-350 & G-OEM-400 SERIES
Operations
Filling and heating
1. Turn control button (1) to select the required cycle time. The pilot
lamp will light up (2).
2. Wait until the machine reaches the correct operating conditions and
the pilot lamp lights up (3).
Wash
1. Remove scraps from tableware before inserting plates in the
dishwasher.
2. Open door, insert tableware, close door.
3. Press the cycle start button (4) which will light up and remain lit until
the end of the cycle.
4. Repeat process when cycle ends.
5. For cold rinse, hold control button in cold rinse position.
Cold rinse.
Only in G/OEM-400
Cleaning products
The detergent and rinse aid dispensers are standard.
(Please refer to user manual for details on the adjustment and operation of the
THE DETERGENT SHOULD BE INDUSTRIAL, HIGH TEMPERATURE,
NON-FOAMING LIQUID DETERGENT
Version with drainage pump
(Mod. B)
dispensers)
Fig.1
Drainage and cleaning
Drainage
1. Turn control button (1) to position "0" (OFF) (Fig. 1).
2. Open the door and remove the overflow (Fig. 3).
DO NOT REMOVE THE FILTER OR LOSE THE O-RING
3. Close the door, turn the control button (1) to the drainage position
(Fig. 1)
4. Press the cycle start button (4) which will light up and remain lit until
the end of the cycle (Fig. 1).
5. Omit steps 3 & 4 in models with gravity drainage
6. Turn control button (1) to position "0" (OFF) (Fig. 1).
Cleaning
1. Open the door, remove over flow cork (Fig. 3) and the filter (4).
2. Clean and dry the machine with a soft cloth. Leave the door open until next
day or next strat-up.
Descaling
1. Insert descaler in the tub and run as many cycles as necessary.
(Please see user manual for further details of this operations)
37
1 2
3
4