ASBER T-OEM-350 Instrucciones De Instalación, Uso Y Mantenimiento página 39

EN
Quick guide
GT-OEM-350 & GT-OEM-400 SERIES
Operations
Filling and heating
1. Close the door, push button (1). The led inside the button (1) will light.
2. Wait until the machine reaches the correct operating conditions. The rinse
temperature (3) must be at least 85°C and the tank temperature (4) should be
at least 55°C.
Wash
1. Remove scraps from tableware before inserting plates in the dishwasher.
2. Open door, insert tableware, close door.
3. Select cycle by pressing button (5), (6) or (7). The leds inside the cycle start
button, indicate the machine is running.
4. Repeat process when cycle ends.
5. In GM-OEM-400 models without soft version, button (7) has double function.
Hold it down to obtain cold rinsing.
Cleaning products
The detergent and rinse aid dispensers are standard.
(Please refer to user manual for details on the adjustment and operation of the
THE DETERGENT SHOULD BE INDUSTRIAL, HIGH TEMPERATURE,
NON-FOAMING LIQUID DETERGENT
7
dispensers)
Fig.1
Drainage and cleaning
Drainage
1.
While the machine is turned on, open the door.
2.
Remove the overflow (Fig. 3).
DO NOT REMOVE THE FILTER OR LOSE THE O-RING
3.
Close the door, push the button (2) for 3 seconds to run drainning. The led light inside the button
(2) starts blinking
4.
Wait until the (2) button led light off.
5.
Omit steps 3 & 4 in models with gravity drainage
6.
Push button (1) to switch off the machine and close the door.
Regeneration
1.
Regeneration cycle in SOFT models has to be done after the draining cycle. Machine must be
empty.
2.
If the Led light (2) is on, fill the can of salts inside the machine
3.
Open the door.
4.
Push button (6) during 3 seconds.
5.
Once the led light inside the button (6) starts blinking, close the door.
6.
Wait until the (6) button led light off.
7.
Clean internal part of machine
Cleaning
1.
Open the door, remove over flow cork (Fig. 3) and the filter (4).
2.
Clean and dry the machine with a soft cloth. Leave the door open until next day or next strat-up.
Descaling
1.
Insert descaler in the tub and run as many cycles as necessary.
(Please see user manual for further details of this operations)
39