Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
6. Turn the locking handle in a clockwise direction to tighten the end support to the vehicles side
rails. Fig. E. The handle must be firmly turned (equivalent to 4Nm or 35 in/ lbs.) to achieve a
positive and tight fit. Always turn the handle clockwise until horizontal to align the lock with the
internal locking position. At the same time the locking jaw is tightened the end support will clamp
the cross bar into position. Repeat this procedure on all end supports.
Fig. E
7. Slide the position slider tabs outboard until they touch the back of the RBU end supports leaving
no gaps. Slide the outer under-cover into place and mark with a pencil for length, remove and cut.
Tip: Cut approx. 1/8" or 2mm longer than needed to avoid gaps. Slide under-covers into place.
Replace the end caps and lock in place. Fig. F.
Position slider tab.
Fig. F
Cut outer under-cover &
slide into place.
59976N Rev B • Questions? (800) 234-6992 • ROLAProducts.com
PAGE 9
Locking jaw firmly pressed
against the vehicle rail.
Slide end caps in
place & lock.
Publicidad
