Operation With The Remote Controller; Automatic Operation; Manual Operation - Panasonic CS-ME7NKE Manual Técnico Y De Servicio

OPERATION WITH THE REMOTE CONTROLLER

1. Automatic Operation

The air conditioner calculates the difference between the
thermostat setting and room temperature, and automatically
selects ''COOL'' or ''HEAT'' mode as appropriate. Then, the air
conditioner continuously operates under the mode selected at
initial operation.
Check that the circuit breaker on the power panel is
NOTE
turned on.
Once mode is selected and the unit is preset by
following the steps below, you can have the air
conditioner automatically bring the room to the
desired temperature simply by pressing the ON/OFF
operation button.
STEP 1
Press the MODE selector button to
STEP 2 Press the ON/OFF operation button.
To stop the air conditioner, press the ON/OFF
operation button again.
• To change the temperature setting; press the
NOTE
temperature setting buttons and change the setting
to the desired temperature.
All manuals and user guides at all-guides.com

2. Manual Operation

STEP 2
STEP 1
.
STEP 4
STEP 5
Check that the circuit breaker on the power panel is
NOTE
turned on.
If the automatic operation settings of the unit do not
meet your needs, press the setting buttons as
described below and change the settings as desired.
STEP 1 Press the MODE selector button
and select the desired mode.
For heating operation
For dehumidifying operation
For cooling operation
STEP 2 To start the air conditioner, press the ON/
OFF operation button.
STEP 3
Press the TEMP. setting buttons to
change the temperature setting to the
desired temperature. The set temperature
appears in the display for only 3 seconds.
Adjustable temperature range:
30 °C max.
16 °C min.
STEP 4
Set the FAN SPEED selector button to the
setting you want.
STEP 5 Press the FLAP button and set the airflow
direction as desired.
(Refer to "ADJUSTING THE AIRFLOW
DIRECTION" on page 15.)
To stop the air conditioner, press the ON/OFF
operation button again.
• When multiple indoor units are used and units in
NOTE
other rooms are already operating, they will be set
to the same mode of operation as the operating
indoor units.
• Choose the best position in the room for the remote
controller, which also acts as the sensor for room
comfort and transmits the operating instructions.
Once you've found this best position, always keep
the remote controller there.
• This appliance has a built-in 5-minute time delay
circuit to ensure reliable operation. When the
operation button is pressed, the compressor will
start running within three minutes. In the event of
power failure, the unit will stop.
STEP 2
STEP 3
STEP 1
→
→
→
or 86 °F max.
60 °F min.
11