PURLINE CHC300D Manual De Empleo página 9

1. Before setting the thermostat, allow heater to
operate and warm up the room. Set thermostat
knob to the maximum setting (+) to start the
heater.
2. When the desired temperature comfort level is
reached, lower the thermostat setting until the
heater stops operating. This is done by moving the
thermostat knob towards the minimum setting (-).
3. The heater will now automatically maintain the
pre-set temperature level by cycling the heater ON
and OFF.
4. It is normal for the heater to cycle ON and OFF as
it maintains the present temperature. To prevent
the unit from cycling, you need to adjust the
thermostat setting.
OVERHEATING SAFETY
1. A thermal overload protector is built into the
heater to prevent overheating.
2. When an overheat temperature is reached, the
heater will be automatically shut off. It can only
resume operation when the user resets the unit
(see reset instruction)
TO RESET THE HEATER
1. Turn the power knob to the OFF (0) position.
2. Unplug the heater and wait 5-10 minutes for the
heater to cool down.
3. After the heater has cool down, plug the heater
into the outlet and operate normally.
:
:
:
TIP OVER SWITCH
Your heater is designed to automatically shut off when
tipped forward or backward.
When returned to normal upright position, heat will
automatically turn on again.
MAINTENANCE
WARNING : ALWAYS UNPLUG THE CORD
BEFORE MOVING OR SERVICING.
DO NOT IMMERSE HEATER IN WATER.
CLEANING :
Clean the heater at least once a month, more often if
dirty. Clean the heater grill with the vacuum brush
attachment on your vacuum cleaner. This will remove lint
and dirt from the inside of the heater.
Do not attempt to take apart the heater.
Do not remove grill guard or allow heater to be operated
without grill guard in place.
Clean the body of the heater with a soft cloth (NEVER
USE ALCOHOL OR SOLVENTS).
STORAGE :
Store the heater with these instructions in its original
carton in a cool, dry place.
SPECIFICATIONS