Attaching And Removing The Nozzle; Connecting To A Water Source; Connecting The High-Pressure Washer To The; Mains Water Supply - Stihl RE 90.0 Manual De Instrucciones

7 Connecting to a water source

6.4.2 Removing the spray lance
2
1
► Squeeze spray lance (1) and spray gun (2) together and
twist as far as they will go.
► Pull spray lance (1) and spray gun (2) apart.
6.5

Attaching and removing the nozzle

6.5.1 Attaching the Nozzle
2
► Push nozzle (1) onto the spray lance (2).
► Turn the nozzle (1) until it engages
► If the nozzle (1) cannot be pushed easily into the spray
lance (2): Grease the gasket on the nozzle (1) with grease
for fittings.
0458-002-8721-A
6.5.2
► Press nozzle (1) and spray lance (2) together and turn
until stop.
► Pull nozzle (1) and spray lance (2) apart.
7 Connecting to a water source
7.1
1
Connecting the water filter
If the high-pressure washer is operated with sandy water or
water from cisterns, a water filter must be connected to the
high-pressure washer. The water filter filters sand and dirt
out of the water and thus protects the components of the
high-pressure washer from damage.
Depending on the market, the water filter may be included
with the high-pressure washer.
► Unscrew the connector.
Removing the nozzle
2

Connecting the high-pressure washer to the

mains water supply

English
1
51