Angelcare AC117 Manual De Usuario página 11

MOVEMENT ALARM
• If NO movement is detected after 15 seconds you will hear
a single 'TIC' pre-alarm sound from the Nursery Unit.
• If after a further 5 seconds there is still NO movement
detected both the Parent Unit and Nursery Unit speakers
will emit loud continuous beeps - this is the Movement Alarm.
• Nursery Unit will flash red light.
• Sensor Pad Icon and sound level bar on Parent Unit will flash.
IF THE ALARM DOES NOT SOUND
• Avoid contact with crib while Sensor Pad is in operation.
• Place crib near a supporting wall.
• Adjust Sensor Pad sensitivity level.
• Turn OFF crib mobile, fans, loud music or anything else that may cause vibration.
TO STOP THE ALARM
Place your hand back
on the mattress.
5.3 - PAUSING AND RESTARTING THE SENSOR PAD
Allows you to pause the Sensor Pad if you remove baby from the crib, e.g. for feeding or comforting.
Pause/Unpause Sensor Pad
IMPORTANT
• If you do not pause the Sensor Pad, the alarm will sound if there is no movement after 20 seconds.
• Ensure to unpause the Sensor Pad before putting baby in the crib.
OR
Press PAUSE button
on the Nursery Unit
OR
1) From the Parent Unit, press and hold
Pause Sensor Pad (OK button)
for at least 2 seconds.
OR
From the Nursery Unit, press
the Pause button
2) To unpause the Sensor Pad, from the
Parent Unit, press the Pause Sensor
Pad button (OK button)
OR
From the Nursery Unit, press the
Pause button.
E
N
Press any button
on the Parent
Unit
11