Angelcare AC117 Manual De Usuario página 17

LOSS OF CONNECTIVITY BETWEEN THE PARENT UNIT AND THE NURSERY UNIT
• In the case of loss of connectivity, the first step is to bring the Parent Unit and Nursery Unit closer together
and make sure that both units are ON to restore the connection. If there is still no connection and no out-of-
range warning after the above has been done, then and only then should the re-connection procedure below
be done.
3
6
Power On/Off Light Indicator
Low Battery Light Indicator
Flashing green
Flashing yellow
Steady green
Sensor Pad Light Indicator
Temperature Indicator
Flashing red
Flashing white
Flashing light blue
Steady Red
Steady Blue
Steady White
1) Turn both Units OFF.
2) Turn the Nursery Unit ON.
3) Press 4 consecutive times the Power ON/OFF
button on the Nursery Unit.
4) Turn the Parent Unit ON. The Out-of-range icon
mode).
5
5) Press and hold the Talk Back button on the
Parent Unit until a beep tone is heard.
6) Press OK button on the Parent Unit. The Out-of-
Range icon
that the Parent Unit is in linking mode.
Nursery unit is using the
back-up batteries
Nursery Unit batteries are low
Monitor is activated
No movement is detected
Monitor is paused
Loss of connectivity between the Nursery
unit and the Sensor Pad
Room temperature is too hot
Room temperature is too cold
Room temperature is good
The Sensor Pad Indicator
Light on the Nursery Unit
will flash quickly in green
(indicates Nursery Unit is in
linking mode).
GREEN
will blink (indicates Nursery Unit is in linking
should blink faster to indicate
E
N
17