Main Components - TRAPP Master 1000 Manual De Instrucciones

Blade
attachment
Transmission
gearbox
Put the machine on a firm surface and loosen the
four bolts (2) and remove the handlebar's
footstrap (3), adjust the right-side handlebar (6),
observing the mounting hole (8). Fit the cord (4)
as shown in the picture, bring the footstrap and
place the two bolts for this side without
tightening them. Then, fit the left-side handlebar
(1) on the other side, also observing the
mounting hole (8), and place the two bolts for
this side in the same way. When the four bolts
are back into place, tighten them. Finally, with
the mower placed on the supporting belt in the
operating position, adjust the distance between
the handlebar's support (5) and the motor (7), at
a comfortable working position.
28

Main components

Blade
locking pin
Allen key
(5 mm)
key
Protection
skirt
Blade
Mounting the handlebar
On/off
switch
Supporting
belt holder
Right-side
handlebar
Left-side
handlebar
Supporting
Belt
7
6
Motor
Plug
Extension
lock
2
1
4
3
8
5
8