TRAPP Master 1000 Manual De Instrucciones página 34

✔
Make sure that the on/off switch is in the "off"
position and that the extension cord is not
connected to the power source.
✔
Put the equipment on a flat surface with the
spool face-up and the handlebars face-down.
✔
Next, put the locking pin (1) into the
mounting hole on the washer (2) to coincide
with the hole on the blade's support base (3)
to lock it.
✔
Then, lock the spool in with the butterfly key
(4) observing the left threading.
32
How to assemble the nylon spool
How to set the nylon filament length
1
4
3
2
Warning!
Don't use the nylon spool without the protection
skirt because that is where the cutting blade that
regulates the maximum length for the nylon
filament is found, which keeps the motor from
overcharging and consequent burning out.
✔
Disconnect the equipment from the power
source.
✔
Pull off the spool face (1) and then turn it to
the left if you want more length and to the
right to shorten it.
✔
If filament length exceeds the ideal size it will
be cut by the blade mounted on the
protection skirt.
1