Connecting Electrical Loads; Stopping The Engine - Firman H07552 El Manual Del Propietario

7. Move
located on
"START"
8. Flip the
switch to
position
seconds
release.
MUST
REMINDER:
INDICATOR LIGHT TO BE ABLE TO START THE
GENERATOR. THE GENERATOR CANNOT BE
STARTED DURING BATTERY POWER SAVING
MODE UNLESS THE FUEL SELECTOR SWITCH IS
TURNED TO THE "OFF" POSITION AND THEN
TURNED
BACK TO THE "LPG" POSITION. See Indicator
light-Battery power Saving Mode section for
more information.
9. Move the choke lever to the "RUN" position.
more receptacles. Also, do not exceed the amperage rating of any one receptacle.
Do not apply heavy electrical load during break-in period (the first five hours of
operations).
1.Let engine stabilize and warm up for a few
English
choke lever
engine to
position.
engine
the
"START"(ll)
for few
and then
3 sec
HAVE
SOLID RED
minutes after starting.
10. Allow generator to run at no load for few
minutes upon each initial start-up to permit
engine and generator to stablize.

Connecting Electrical Loads

This unit has been pretested and adjusted to
handle its full capacity. Before starting the
generator, disconnect all load. Apply load only
after generator is running. Voltage is regulated via
the engine speed adjusted at the factory for
correct output. Readjusting will void warranty.
CAUTION
When applying a load, do not exceed the
maximum wattage rating of the generator when
using one or working on nearby power lines. If you
plan to run a portable electric generator during an
outage, please notify your electric utility company
immediately and remember to plug your
appliances directly into the generator. Do not plug
the generator into any electric outlet in your home.
Doing so could create a connection to the utility
company power lines. You are responsible for
ensuring that your generator's electricity does not
feed back into the electric utility power lines. If the
generator will be connected to a building electrical
system, consult your local utility company or a
qualified electrician. Connections must isolate
generator power from utility power and must
comply with all applicable laws and codes.

Stopping the Engine

1. Turn off and remove entire electrical loads.
Never start or stop the generator with
devices
turned on.
electrical
plugged in or
Customer Service: 1-844-FIRMAN1Page 16