Publicidad
Idiomas disponibles
Idiomas disponibles
The system is not intended to be used for treating water that is microbiologically
unsafe or of unknown quality without adequate disinfection before or after the system
p
reinsTallaTion
General:
• Observe all warnings that appear in this manual.
• Keep media tank in the upright position. Do not turn upside down or drop. Turning the tank upside
down will cause media (resin) to enter the valve.
• Operating ambient temperature is between 39.2 ˚F (4 ˚C) and 104 ˚F (49 ˚C).
• Operating water temperature is between 39.2 ˚F (4 ˚C) and 104 ˚F (40 ˚C).
• Working water pressure range is 30 psi to 125 psi (USA) and 30 psi to 100 psi (Canada) .
• Follow state and local codes for water testing. Do not use water that is microbiologically unsafe or of
unknown quality.
• When filling the media tank with water, do not open main water valve completely. Fill tank slowly to
prevent media from exiting the tank.
• Allow welded or soldered parts to cool and set before installing any plastic parts.
Location Selection:
Location of a water treatment system is important. The following conditions are required:
• As close as possible to the incoming main water supply.
• As close as possible to the floor drain.
• To soften all water in the home, install the softener to the main water supply inlet before the in-line
filtration system (if applicable) and before all other plumbing connections, except outside water lines.
Outside faucets should remain on hard water to avoid wasting conditioned water and salt.
• Connect the softener to the main water supply line "before" the water heater.
• Level platform on floor.
• Allow floor space to access equipment for maintenance and adding regenerant (salt) to tank.
• Constant electrical supply to operate controller.
• Total minimum pipe to water heater of 10 ft. to prevent backup of hot water into system.
• Water line connections with shutoff valve.
• Must meet any local or state codes for site of installation.
CAUTION: DO NOT run hot water through the softener.
Temperature of water passing through the softener must be less
CAUTION: DO NOT install the softener in a location where it
can freeze. Damage caused by freezing is not covered by the
Kit Includes:
• 120-V/60-Hz AC adapter plug (12V DC Output).
• ½" I.D. Drain hose (4.1 m / 13.5ft) and clamp.
• ½" I.D. Overflow hose (2.1 m / 6.9ft) and clamp.
• Bypass Assembly with ¾" NPT male threads for inlet and outlet ports and clips.
• ¾" short inlet adapter.
• Neck wrench.
i
nsTruCTions
than 104 ˚F/ 40 ˚C.
warranty.
1
Publicidad
