End Of Operation - diversey Taski Swingo 455B Traducción De Las Instrucciones Originales De Usщ

Battery capacity - end of operational readiness
• The battery level indicator notifies
you that the machine is ready for op-
eration.
• Blinking red LED:
2 minutes to finish working before the machine automati-
cally switches off.
• Solid red LED:
Requires a full charging cycle.
Cleaning method
Direct working method:
Scrubbing and suction in one work step.
Indirect working method:
Applying the cleaning solution, scrubbing and suction in several work
steps.
Notice:
In some circumstances, certain combinations of
flooring/soiling and cleaning products may impair
the guiding of the machine.
- Optionally available wheels can improve the ma-
chine's traction on the floor. Please contact your TAS-
KI customer consultant.
Replenishing cleaning solvent
Warning:
The flooring may be damaged when working with-
out cleaning solution.
Caution:
A rattling sound of the pump indicates that the
fresh water tank is empty.
- The pump must never run dry for an extended period.
• The machine must be switched off.
• Open the tank lid.
• Fill the fresh water tank with water, see page 7.
• Add the cleaning product using the dosing cup.
• Close the tank cover.
Draining dirty water
• If the recovery tank is full, the floater
will be sucked onto the suction filter.
This will be indicated by a change of
the noise by increasing the suction
speed as well as residual water at the
bottom.
• Drain the recovery tank, see page 10.

End of operation

• Press the Brush drive ON/OFF but-
ton.
The cleaning solution supply is
stopped.
• Drive on for a few meters so that the brushes keep on ro-
tating for a short time to avoid dripping.
Very important for TASKI contact pads!
• To lift the tool, push the foot pedal
downwards until it engages.
• Drive on for a few meters in order to absorb the remaining
drain water.
• Lift the suction nozzle.
Allow the suction unit to run on so
that the remaining waste water in the
hose is sucked up.
• Press the Suction unit ON/OFF but-
ton.
The display lights up; the suction en-
gine stops.
• Switch off the machine.
Caution:
The machine must now be emptied and cleaned.
Switch off the machine (main switch) and discon-
nect the battery disconnection socket before begin-
ning with the following steps.
Removing and cleaning the suction nozzle
• Pull the suction hose from the connector.
• Lift the suction nozzle with your foot.
• Compress the lock springs. The suc-
tion nozzle is released and can be re-
moved from the squeegee holder.
• Clean the suction nozzle under running water using a
brush.
Notice:
Only cleaned and intact blades ensure optimal suc-
tion results!
9