Opening The Safe; Clearing The Memory - STACK-ON QAS-1810-B Manual De Instrucciones

OPENING THE SAFE

To open the safe, press the scanner with a
recorded finger. The light will come on with
one beep (if the sound is turned on) and the
scan will begin.
If the green light fashes twice with 2 beeps (if the
sound is turned on), the scan has been accepted
and the drawer will open.
If the red light flashes 1X, the scanner did not
read your fingerprint and you must try again. If
the red light flashes 3 times, the scanner read
your fingerprint and did not accept it.
If there are 3 rejected scans, where your
fingerprint was read, and the red light flashes
5X and beeps 5X (if the sound is turned on)
alarm will sound for 10 seconds resulting in the
safe being automatically locked out for
1 Minute before you can try your code again.
The safe will beep 1X (if the sound is turned on)
and the green light will flash 1X when the
lockout period is over.
If there is 1 more rejected scan where your
fingerprint was read and the red light flashes
5X and beeps 5X (if the sound is turned on)
alarm will sound for 30 seconds resulting in the
safe being automatically locked out for
5 minutes before the code can be tried again.
The safe will beep 1X (if the sound is turned on)
and the green light will flash 1X when the
lockout period is over.
To close the safe, push the drawer closed
until locked.
TURNING THE KEYPAD SOUND
OFF/ON
Your safe comes with the "Beep" sound
turned on.
You can turn off the "Beep" sound of the
keypad by pressing all the buttons at the same
time and holding for 3 seconds until the green
light flashes.
To turn the "Beep" sound on, press the left and
middle button at the same time and hold for 3
seconds until the green light flashes.
INTERNAL LED LIGHT
then
This safe includes an internal LED light that will
activate when a recorded fingerprint is scanned
and will remain on for 30 seconds.

CLEARING THE MEMORY

To clear the memory of all recorded
fingerprints, locate the reset button on the
inside of the safe and press this button for
then about 5 seconds until the green light flashes
10X. All recorded scans will be erased.
NOTE: For security you must record a
fingerprint. Failure to do so will compromise
the safety and security of the safe.
4
14
40789-1806