Locking The Safe; Clearing The Memory - STACK-ON SHD-AOTT-BG-B Instrucciones

RECORDING FINGERPRINTS
When you first receive your safe there are no
recorded fingerprints. Any fingerprint will open the
safe until a fingerprint is recorded. For security you
must record a fingerprint.
Failure to do so will compromise the safety and
security of the safe.
You can record up to 20 different fingerprints for
opening the safe. For best results, each individual
should use their thumb or index finger only.
Before you can record a fingerprint, with the door
open, the key must be in the locked position - you
can not program the keypad if the key is in the
unlocked position.
To record a fingerprint, first press the Reset Button
on the inside of the safe with a pen and then
release it. The scanner will turn blue with two beeps
(if the sound is turned on) and the green light flashes
twice, you will then record the same finger three
times as follows:
1. Place your finger on the scanner until there
is one beep (if the sound is turned on) and the
green light flashes once. Lift your finger off
the scanner.
2. Place the same finger on the scanner for a
second time, holding the finger in the same
position until there is one beep (if the sound is
turned on) and the green light flashes once.
Lift your finger off the scanner.
3. Place the same finger on the scanner for a
third time, holding the finger in the same position
until there are two beeps (if the sound is turned
on) and the green light flashes twice.
Lift your finger off the scanner. Your fingerprint is
now recorded.
SCAN THE SAME FINGER 3X
If the red light flashes three times with three beeps
(if the sound is turned on) your fingerprint did not
get recorded and you will have to start over.
If you enter more than 20 fingerprints, the red light
will flash 5 times and there will be 5 beeps
(if the sound is turned on).
NOTE: In certain dry climate conditions, your
fingerprint may not scan. If your fingerprint did not
scan, we recommend moisturizing with minimal
lotion and trying again.
NOTE: DO NOT SHUT THE DOOR UNTIL YOU
HAVE CONFIRMED THAT YOUR FINGERPRINT
HAS BEEN ENTERED CORRECTLY.

LOCKING THE SAFE

NOTE ON LOCKING THE SAFE: Because the
locking mechanism is deactivated for
approximately 3 to 6 seconds after the
combination is entered, wait a minimum of 6
seconds from the time the
to lock the safe.
When operating the lock with the key, you must
turn the key back to the locked position before
you are able to close and lock the safe door.

CLEARING THE MEMORY

To clear the memory of all recorded fingerprints,
locate the reset button inside the safe and press
this button for about 5 seconds until the green
light flashes 10 times with 10 beeps (if the sound
is turned on). All recorded scans will be erased.
NOTE: For security you must record a
fingerprint. Failure to do so will compromise
the safety and security of the safe.
combination is entered
3
16
40715-1705