Rampage Trailview Tonneau Top Instrucciones De Instalación página 5

Installation Steps
TIP: Make sure the rubber gasket at the top of the windshield is correctly
sealed against the front surround section. See photo below for proper fit:
12
Fit retention strap to driver side door surround mount plate on top of rear
hole in mount plate to hold tube when top is open.
14
Next, install the 2nd washer and Nylock nut on top of the strap and snug
with a 13mm socket wrench and 13mm wrench.
16
Tighten all door surround knobs into door surround assembly at this time as shown below. Repeat steps on right side.
18
Fit door surround mount plate on top of door surrounds.
13
Put the retention strap in place with the bolt and washer through the
grommet as shown.
15
When the top is in the folded back position reach up and hook the retention
strap over the bar as shown.
17
5