Descargar Imprimir esta página

Fein KFH17-8 Manual Del Usuario página 9

Ocultar thumbs Ver también para KFH17-8:

Publicidad

Idiomas disponibles

Idiomas disponibles

Extension cable.
If the use of an extension cord
WARNING
is required, its length and con-
ductor cross-section must be adequate for the
application in order to prevent a voltage drop
in the extension cord, power loss and over-
heating of the power tool. Otherwise, the
extension cable and power tool are prone to
electrical danger, and the working efficiency is
decreased.
Intended use of the power tool:
hand-guided bevel milling machine for profes-
sional use by instructed operating personnel
in weather-protected environments using the
application tools and accessories recom-
mended by FEIN:
– for machining workpieces made of steel,
cast steel, fine-grained steel, stainless steel,
aluminum, aluminum alloys, brass and plas-
tic
Operation of the power tool off power generators.
This power tool is also suitable for use
with AC generators with sufficient power
output that correspond to the Standard
ISO 8528, design type G2. This Standard is
particularly not complied with when the so-
called distortion factor exceeds 10 %. When
in doubt, please refer to the generator
instruction/specification guide.
Symbols.
Symbol, character
Explanation
Make sure to read the enclosed documents such as the Instruction
Manual and the General Safety Instructions.
Observe the instructions in the text or graphic opposite!
Observe the instructions in the text or graphic opposite!
General prohibition sign. This action is prohibited.
Before commencing this working step, pull the power plug out of the
socket. Otherwise there will be danger of injury if the power tool
should start unintentionally.
Recommended dimensions of extension cords
at an operating voltage of 120 V – single-
phase a. c., with only KFK17-8 (**)/
KFH17-15 (**) connected:
Max. cable length, ft
≤ 100
100
200
–200
–300
Min. conductor size
A.W.G.
16
14
– for commercial use in industry and trade
– for the preparation of K-, V-, X- and Y-
shaped welding joints
– for machining visible edges in plant, equip-
ment and general engineering
– for rounding edges for optimal paint prep-
aration or as impact protection
Operating the power tool off
WARNING
power generators whose no-
load speed exceeds the voltage value on the
type plate of the power tool is prohibited.
en
Max. cable length, m
≤ 30
30
– 60
Min. conductorcross-
2
section, mm
12
1.5
2.5
9
60
–100
4

Publicidad

loading