De-Activate Direct Control - Motion CM-08 Manual De Instrucciones

15
Reset favourite position
Centre
16

De-activate direct control

When pressing the up or down button on the remote control the blind directly moves to
its end positions (direct control). To operate the blind with smaller steps using the up and
down button, direct control can be de-activated. Now, the blind only directly moves to its end
positons when the up or down button is held longer than two seconds.
Press the program button on the motor to activate
16.1
program mode. The blind starts stepping.
Hold the program button until the blind stops stepping (approximately 5 seconds)
16.2
to de-activate or re-activate direct control.
MOTION CM-08 LI-ION END MOTOR
Move the blind to a desired favourite position.
15.1
Press the program button on the motor to activate
15.2
program mode. The blind starts stepping.
Hold the centre button to save this favourite position. The blind shortly
15.3
stops stepping indicating the favourite position has been saved succesfully.
Press the program button on the motor to de-activate
15.4
program mode. The blind stops stepping.