Motion CM-08 Manual De Instrucciones página 19

17 Reset the blind
It is possible to only delete end limits or to do a factory reset.
Factory reset will delete the end limits and remove the connection to any paired remote.
Press the program button on the motor to activate program mode.
17.1
Delete end limits: To delete the end limits of the blind hold the program button
until the blind stops stepping for the first time, keep holding the button until the
blind stops stepping for the second time. (approximately 10 seconds)
Factory reset: To reset the blind to factory defaults hold the button for at least 20 seconds.The blind will
stop stepping twice. After the second stop the blind will give one extra step to confirm factory reset.
18 Recharge the battery
LED light flashes
red during operation;
charge the battery.
MOTION CM-08 LI-ION END MOTOR
LED light flashes
green;
battery is charging.
Use a micro USB cable
to charge the motor.
LED light constantly
battery is fully charged.
green;