REVAMP Professional CL-2250 Manual Del Usuario página 3

• Separate each layer of hair into sections of 3 cm wide. Smooth each section of hair by
brushing or combing through the section (from scalp to hair ends) prior to curling.
• For extra protection, apply a heat protection spray.
C
D
• VERY IMPORTANT - When curling your own hair, be sure to hold the device with the
buttons facing towards you, see (A). If curling a friend's hair for them, have the buttons
facing towards them. Always make sure that the control
buttons with the REVAMP logo located on the front of the
A
product are facing you or your friend's face.
• Thread the hair through the small recess at the front of
the product, then down through the deeper aperture
at the back of the product as shown in (C). Hold the
appliance around 50-75mm away from your head. (A)
• Choose the direction of the curl by pressing the right
or left curling button (feature 2) as shown in diagram D.
Work on one side of the head at a time. When you move
on to the other side, press the opposite direction curling button so that your curls are
symetrical (D).
• VERY IMPORTANT - Please do not put your fingers in the deep aperture at the back of
the product or try to touch the hot barrel.
• Press and hold the curling button and the hair will be automatically wrap around the
heated barrel.
• Keep holding the button while the hair is wrapped around the barrel and until you hear
the beep.
• The curling system stops and a beep is heard after 10 seconds which is sufficient time
to curl normal hair.
• After hearing the beep, release the button and wait for the barrel to stop rotating
before lowering the appliance from the hair to release your curl.
• Caution! When the curling mechanism has stopped, always pull the product downwards
to release the curl.
• Repeat for each hair section, allowing each curl time to cool in between.
• After use, switch off the appliance, unplug and allow to cool before storing away.
• THE PRODUCT MAY JAM IF TOO MUCH HAIR IS FED AROUND THE BARREL. In this case, the
product will automatically shut off. Simply pull the product down to release the hair and
turn back on again to continue using.
Follow us on www.revamphair.com for the latest hair tips and advice.
Please note:
• Avoid over-use of styling products as this may deteriorate the coating on the barrel.
• The heated barrel and top end of the appliance get very hot during use. To avoid burns,
keep the barrel away from direct contact with the head and only hold the appliance by
the handle.
• While heating, during use and cooling, place on the REVAMP heat-resistant mat. Only
hold the product by the cool handle.
• Do not scratch the surface of the curl barrel as this will deteriorate the effectiveness of
the coating.
• The product reaches a very high temperature during operation, please style with
caution when using. Make sure to keep away from the scalp and skin to avoid burns.
B D E