durher Ordesa M Manual De Instrucciones página 32

Diamond blade assembly:
Extract the aerial base from the supply.
Open the upper cover top (PC130172), remov-
ing the M-6 butterfly nuts (PC140162) placed
at the front part of the cover.
Block the motor shaft, with the round spanner
(PC130066) and loosen the bolt (PC120090)
with the 30 spanner (PC130065), clockwise (A).
Graphic 2.8. Cutting blade assembly
Extract the external plate (PC000562).
Put the cutting blade in place, after checking
the internal diameter of the blade and the turn-
ing direction. The turning direction should coin-
cide with that shown on the top cover.
Fix the cutting blade with the external plate
and tighten the bolt anticlockwise (B), check-
ing the correct position in the housing.
A
B
Close the lower cover top and screw down the
bolts.
Place the aerial base in the current supply box
again, (see graphic 2.8.).
Upon starting up the machine, check that the
blade makes no strange movements and
turns in the direction indicated on the top
cover.
Longitudinal guide assembly:
The longitudinal cutting (PC130207) is placed
at the top
(TE000026/OR000010). Then it is fixed to the
rear end (TE000016), with the adjusting bolt.
The guide can be adjusted by the carriage at
different positions.
The ruler behind the guide can be placed at
various degrees by only loosening the M-10
bolt (PC130212) located at the top part (See
Graphic 2.9.).
Graphic 2.9. Longitudinal guide assembly
Rear flap assembly:
The rear flap (TE000064) is placed at the lower
part of the arm (TE000120/ OR000019), open-
ing the support stud and anchoring it, in the first
35
par t of the carriage