durher Ordesa M Manual De Instrucciones página 43

The user of this machine should additionally
comply with current health and safety at work
regulations.
The machine is not designed to cut any type of
products other than ceramic material and
masonry.
Block the transport vehicle before unloading or
loading the machine.
The unloading and loading of the machine will be
carried out in accordance with the methods indi-
cated in chapter 2.3. Unloading and unpacking.
The maintenace tasks of the electric installa-
tions should only be carried out by qualified per-
sonnel and will always have to comply with the
Health and Safety at work national regulations.
The electric installation where the dovetail cutter
is to be installed should have the appropriate
protections against surges and earthing defects.
The machine should be correctly earth con-
nected.
In the event of malfunctions in the electric pro-
tection devices, the machine should be put out
of service and repair the malfunctions in the
correct and adequate way.
In the event of loss or deterioration of any pic-
togram, advice or charcateristics plate, this
should be immediately replaced by another
one of the same characteristics.
Any non-compliance with the instructions of the
manual or modification of the machine exempts
the manufcaturer from any responsibility.
Any maintenance handling of the machine
should be carried out by qualified personnel.
DO NOT PUT THE MACHINE IN OPERATION IF
THE ELEMENTS AND COVERS ARE NOT
CORRECTLY PLACED AND FIXED.
The machine should not be put in operation if
it is not correctly supported on its four legs.
The machine electrical system should not be
modified.
Any replacement of the machine should also
be with original elements.
All the adjustment, maintenance and cleaning
operations should be carried out with the
machine stopped and disconnected.
Please take care when handling the cutting
blade.
When using large size pieces, the possible
falling of the piece or cut pieces off the cutting
table should be taken into consideration.
USING BLADES OF A DIAMETER LESS THAN
300 mm. OR MORE THAN 350 mm. IS COM-
PLETELY FORBIDDEN.
USING BLADES OF An AN INTERNAL DIA-
METER DIFFERENT FROM 25.4 mm. IS
COMPLETELY.
Do not work with the machine where there is
insufficient lighting.
The use of the machine in places with fire or
explosion hazards is completely forbidden.
46