Assembly & Installation Procedures; Hitch Assembly - Husky 31313 Instrucciones De Montaje, Instalación, Funcionamiento Y Mantenimiento

Assembly & Installation

1. Hitch Assembly

a) If using pre-existing base rails ensure that the center to center (fore and aft) distance is 22" and that there are
two pairs of slots in the base rails that are 20 5/8" apart (side to side). Otherwise contact your local dealer
for proper base rail selection and installation.
b) Place the uprights into the base rails with the decals facing the rear of the truck. Secure the uprights to the
base rails using the 1 / 2 inch diameter rail pins and secure using the large hairclips in the hardware bag.
c) With the Warning Label of the cross member facing to the driver side of the truck, slide the cross member
assembly downward over the uprights. Determine the mounting holes to obtain the proper height of the
hitch head, and from the inside insert the four 1/2" diameter bolts into the appropriate cross member
mounting holes and thru each body side. Note: inserting the bolts from the inside will put the lock nuts
on the outside of the cross member, this will ensure that the proper torque will be applied to the lock
nuts.
All Products limited to Vehicle Tow Rating; see Vehicle Owners Manual. See
Warranty Information / Tech Support ©2014 Husky Towing Products June 3, 2014-REV 4
Procedures
5 of 61
www.huskytow.com for