Forced Flow Rate; Information Texts And Error Messages; Information Texts; Error Messages - MURPROTEC CTA Instrucciones De Uso

5. FORCED FLOW RATE

This menu is a shortcut to the temporary mode.
Press or

6. INFORMATION TEXTS AND ERROR MESSAGES

6.1. Information texts

Text
Change filter in
x days
Change filter
Change filterimmediately.
System failure!
--T° too high or too low --
--- FILTER ---
-DID YOU CHANGE THE
FILTER?
--- MANUAL STOP ---

6.2. Error messages

Text
No display
(empty screen)
--- NO FILTER ---
---SPEED ERROR ---
--- T° ERROR ---
46
to access the menu when the home screen is displayed; Press
Explanation
The filter is near its lifecycle. It is time to order a replacement.
The filter is clogged. It has to be changed.
The filter is saturated and no longer 100% effective. You risk damaging your device and
fouling your home.
The temperature in the machine exceeds the limit set by the installer or is below 3°C
Question asked when filter is removed. Answer YES only if you have put in a new filter and
cleaned the system (cf. § 7)
See in the "Stop" menus; the fan stops. Follow the instructions to restart the device.
Explanation
Caused by low voltage or power outage
There is no filter in the device.
Speed reading problem.
Temperature reading problem.
to quit.
Solution
Make sure there is no power outage;
no incidence on the device.
Put in a new filter (see § 7) or clean the sensor
with an antistatic brush.
Call the number displayed on your control
panel.
Call the number displayed on your control
panel.